One Watt Initiative

The One Watt Initiative is an energy-saving initiative by the International Energy Agency (IEA) to reduce standby power-use by any appliance to no more than one watt in 2010, and 0.5 watts in 2013, which has given rise to regulations in many countries and regions.

Standby power

Standby power, informally called vampire or phantom power, refers to the electricity consumed by many appliances when they are switched off or in standby mode. The typical standby power per appliance is low (typically from less than 1 to 25 W), but, when multiplied by the billions of appliances in houses and in commercial buildings, standby losses represent a significant fraction of total world electricity use.<ref>One Watt Initiative : a Global Effort to Reduce Leaking Electricity Alan Meier & Benoît LeBot, 1999</ref> According to Alan Meier, a staff scientist at the Lawrence Berkeley National Laboratory, standby power before the One Watt Initiative proposals were implemented as regulations accounted for as much as 10% of household power consumption. A study in France found that standby power accounted for 7% of total residential consumption, and other studies put the proportion of consumption due to standby power at 13%.<ref>Pulling the plug on standby power, The Economist 9 March 2006,</ref>

The IEA estimated in 2007 that standby produced 1% of the world's carbon dioxide (CO₂) emissions.<ref>Should we ban these bulbs? The Guardian, 22 February 2007</ref> To put the figure into context, total air travel contributes less than 3% of global CO₂ emissions.<ref>Flying the cleanly skies? The Christian Science Monitor, 12 February 2007</ref>

Standby power can be reduced by technological means, reducing power used without affecting functionality, and by changing users' operating procedures.

Policy

The One Watt Initiative was launched by the IEA in 1999 to ensure through international cooperation that by 2010 all new appliances sold in the world use only one watt in standby mode. This would reduce CO₂ emissions by 50 million tons in the OECD countries alone by 2010; the equivalent to removing 18 million cars from the roads.<ref>Global Implication of Standby Power Use, ACEEE Summer Study 2000. Lebot B. & Meier A</ref>

In 2001, US President George W. Bush issued Executive Order 13221,<ref>Bush, George W. (31 July 2001). "Executive Order: Energy Efficient Standby Power Devices". The White House. Retrieved 24 September 2022.</ref> which states that every government agency, "when it purchases commercially available, off-the-shelf products that use external standby power devices, or that contain an internal standby power function, shall purchase products that use no more than one watt in their standby power consuming mode."<ref>"Pulling the plug on standby power". The Economist. 9 March 2006. Retrieved 24 September 2022.</ref>

By 2005, South Korea and Australia had introduced the one watt benchmark in all new electrical devices, and according to the IEA other countries, notably Japan and China, had undertaken "strong measures" to reduce standby power use.<ref>"Standby power use and the IEA, One Watt Plan – Fact Sheet" (PDF). International Energy Agency. 2005. Archived from the original (PDF) on 28 April 2017.</ref>

In July 2007, California's 2005 appliance standards came into effect, limiting external power supply standby power to 0.5 watts.<ref>"California Slays 'Energy Vampires'; More Stringent Regulations Took Effect July 1". Flex Your Power. Archived from the original on 9 February 2011. Retrieved 16 September 2010.</ref>

On 6 January 2010, the European Commission's EC Regulation 1275/2008 came into force regulating requirements for standby and "off mode" electric power consumption of electrical and electronic household and office equipment. The regulations mandate that from 6 January 2010 "off mode" and standby power shall not exceed 1 W, "standby-plus" power (providing information or status display in addition to possible reactivation function) shall not exceed 2 W (these figures are halved on 6 January 2013). Equipment must, where appropriate, provide off mode and/or standby mode when the equipment is connected to the mains power source.<ref>"Standby and off leaflet" (PDF). United Kingdom: Department for Business, Innovation and Skills. Archived from the original (PDF) on 9 November 2011.</ref>

See also

• Carbon footprint
• Energy conservation
• Energy-Efficient Ethernet
• Energy policy
• Low-carbon economy
• Standby power
• Voltage optimisation

External links

• Things that go blip in the night, Standby power and how to limit it, International Energy Agency/Organisation for Economic Co-operation and Development, Paris, 2001
• International Energy Agency
• Standby Power Home Page, Lawrence Berkeley National Laboratory California